How to Restore a Non-Stick Pan

“Frying Pans…Who Knew Right?” -Flynn Ryder

There is literally nothing worse than having a pan that is not so non-stick anymore. Everything burns to the bottom and then you have to spend forever scrubbing the stupid thing. We tried everything to restore this old pan before letting it go. We found a trick for you that actually works. It super simple too. Chances are that you already have everything you need inside your kitchen.

All you need:

  • Old Frying Pan
  • 1 Tablespoons Coconut Oil

Gemini&Archer Supplies.PNG

 

  1. Heat your pan for 2-3 minutes. Once your pan is hot, add the 2 tablespoons coconut oil.

Restore Pan Gemini&Archer.PNG

 

2. Swirl the coconut oil around in the pan, so that the entire surface is coated. Once the coconut oil starts to smoke, remove it from heat and let cool.

3. Once the pan is cool take a paper towel and rub the left over oil into the pan.

coconut-oil-geminiarcher

 

4. Your pan is as good as new.By heating the pan you open the natural spores to allow the coconut oil to penetrate into the surface. We hope this helped to make your life a little easier and cleaning to not be so tedious.

Restore Nonstick Pan Gemini&Archer.PNG

Advertisements

How to Make Your Toaster Look Like New.

“It doesn’t matter how ready you think you are. The toaster will always scare you.” -Unknown

Sometimes the little things, such as cleaning the toaster can be easily ignored. Then one day it gets so bad, your surprised at how dirty it has become. That’s what happened to us. There is so much build up, it makes it harder to clean. It’s not just a spot treatment anymore. Today we are going to show you how to make your toaster look new again. You just need a few things.

What you will need:

  • Dirty Toaster (please don’t judge us) 🙂
  • Your Favorite Dish Soap
  • Clean Paint Brush
  • Stainless Steal Polish
  • Sponge
  • Water

gemini and archer toaster.PNG

 

  1. Here is our toaster. As you can see it is full of crumbs and seeds at the bottom. Usually we just flip it upside down over the trash and shake hoping that most of it will come out. We did not even realize that there is a little tray that slides out.

clean toaster gemini and archer.PNG

 

2. The crumb tray is usually located in the back/bottom of the toaster. It should have a tab and slide right out.

toaster crumb tray.PNG

3. Ours had quite a bit of build up. We shook the loose crumbs into the trash and soaked the tray in warm soapy water.

gemini and archer soak.PNG

 

4. Next we turned the toaster upside down and shook the rest of the crumbs out.

gemini and archer  tutorial.PNG

 

5. After shaking all the crumbs loose, we took our little paintbrush with warm soapy water and cleaned out the crevices.

gemini and archer diy toaster.PNG

 

6. Now it is time to focus on the outside. Take a sponge and dip into warm soapy water again. Clean the outside and be gentle not to scratch the surface. Dry with a soft cloth.

gemini and archer toaster cleaning.PNG

 

7. Last take your stainless steel cleaner (this is our favorite part), and polish according to manufacturers directions.

toaster polish.PNG

 

This is what our toaster looked like after…Inside and out.

inside-toaster-cleaning-diytoaster-result-gemini-and-archer

 

 

Thank you for following along with us. Your toaster will look as good as new in no time. Enjoy!

owing along with us. Your toaster will look as good as new in no time. Enjoy!